Key Chain Remote Controller

The Z-Wave.Me Key Fob is a Z-Wave device that can both control other Z-Wave devices and activate predefined scenes in an IP gateway. Although it is controlling other devices the KFOB can’t act as Z-Wave network controller (primary or secondary) and will always need a Z-Wave network controller to be included into a Z-Wave network. The KFOB can be used in five different modes that are picked by configuration commands:

  1. Direct Control of associated Devices with single Buttons association group 1 is controlled by button 1, group 2 by button 2 etc., Single Click = On, Double Click = Off, Hold = Dim up, Click and Hold = Dim down
  2. Direct Control of associated Devices with two Buttons, association group 1 is controlled by the two buttons #1 and #3, association group 2 is controlled by the two buttons #2 and #4. Click of the larger button = On, Click of the smaller button = off, hold the larger buttons = Dim up, Hold the smaller button = Dim down
  3. Scene Activation in IP Gateway Clicking a button activates a corresponding scene in an IP gateway if the IP gateway is configured accordingly.
  4. Direct Activation of preconfigured Scenes Associated devices in an association are controlled by individual commands defines by Z-Wave command class. This function enhances mode 1.
  5. Direct Control of Devices in proximity pushing button 1 or 2 turns on a device in short distance (50...100 cm) from the fob, button 3 or 4 turns of a device in proximity.





The new RaZberry Controller Software Version 2.0 now supports Apple HomeKit. Check out more details here or you straight to the RaZberry Home Page.